Height Measurement Injector Height Gauge Kit For Injector Installation

Label:Yes Applicable Model: The injector height gauge kit is applicable for Detroit Diesel Engines 50 60 Series, similar to J-42749, J-45002, J-39697, J-42665, J-35637-A. OE Number: The referencing OE number of this injector height gauge kit is 3350, which is molded and designed depend on the original data. Practical: Properly set injector body height to the injector follower for proper fuel injector timing. Incorrect injector timing can cause engine power issues, poor idle quality and fuel mileage issues. Easier Work: Be sure the height gage seats on the machined surface with the tip in the pilot hole. Adjust the height until you can slide over it and find that slight drag. Package Includes: Includes 78.2mm, 78.8mm, 80.3mm, 81.0mm and 82.1mm gauge blocks along with knurled handle that allows for use in areas with restricted access. Main Function: Used to correctly set the injector body height to the injector follower to achieve correct injector timing.

Item Type: Injector Height Gauge Kit OE Number: 3350 Material: Steel Fitment: Replacement for Detroit Diesel Engines Series 50 and 60 Model: 78.2mm (Series 60, Engine: 1986-1993 DDEC I) 78.2mm (Series 60 and 50, Engine: 1986-1993 DDEC II) 78.8mm (Series 60 and 50, Engine: 1994-1997 DDEC III) 80.3mm (Series 60, Engine: Late 1997 DDEC III) 80.3mm (Series 60 and 50, Engine: 1997-1998 DDEC IV) 81.0mm (Series 60 and 50, Engine: 1998-1999 DDEC IV) 81.0mm (Series 60, Engine: 2000-2003 Marine) 82.1mm (Series 60) 1 x Knurled Handle 5 x Gauge Block Please double check the part number of your item, matching information is for reference only.