Self-Adhesive Shoe Bottom Protector Clear Sole Cover Protectors Practical Shoe Pads Indoor

Label:Yes SILICONE RUBBER WITH A WATERPROOF BACKING: The body is silicone rubber, so the face stays firm through daily steps and does not split easily, and the waterproof backing stands up to wear and weather over a long stretch, which supports a long service life on shoes you keep in regular use through wet days and dry days alike CUT FROM A STRIP ABOUT 3.9 INCHES WIDE AND 3.3 FEET LONG: The strip measures about 10 centimeters or 3.9 inches in width and about 1 meter or 3.3 feet in length, so you can cut a piece for a heel tip, the ball of the foot, or a wider patch to suit any shoe, and the length gives enough material for more than a single pair SELF ADHESIVE SOLE PATCH: Press this sticker onto the area where the shoe meets the ground so the special surface can help the sole hold there, and that grip also helps keep the shoe from sliding off the foot during a walk, which gives a steadier step through daily wear and the sticker stays seated through a full day of wear CLEAR FACE THAT PEELS AWAY CLEAN: The clear body sits close to the shoe so the color still shows through and the patch is hard to notice from a short distance, and when you peel it off the surface stays clear without a sticky film left behind, while the layer protects the contact area and does not harm the heel or the shoe, which keeps the pair looking neat after many wears FOR HIGH HEELS STILETTOS BOOTS AND OTHER SHOES: This sticker suits high heels, stilettos, and boots, and it also fits other pairs you wear through the day, so a heel pair and a boot pair can both use it, which helps the shoe stay on the foot while you walk

Item Type: Shoes Sole Stickers Material: Silicone Rubber Product Color: Clear Width: Approx. 10cm / 3.9in Length: Approx. 1m / 3.3ft Product Weight: Approx. 60g / 2.12oz

Instructions: 1. Prepare the necessary tools: Sole stickers, small scissors. 2. Cut the appropriate length, only need to paste the front part of the high-heeled shoes that is in contact with the ground. Generally, the high-heeled shoes can be pasted 3 pairs per meter, and the flat-bottomed shoes can be pasted 2 pairs (the heel cannot be pasted). 3. Tear off the white release paper on the back and start pasting. When pasting, tear off the side stickers from top to bottom to squeeze out the air as much as possible. 4. Cut off the edges and hold it with the sole facing upwards when trimming, so it is easier to cut. 5. After sticking, press hard and repeatedly to make it firm. Wear shoes 24 hours after application. The replacement method of the sole sticker: First use a hair dryer to heat the insole to soften the glue, and then slowly tear it off (remember not to tear it off directly to avoid hurting the surface coating of the sole).

Package List: 1 x Shoes Sole Sticker

Notes: 1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. 2. Please allow slight manual measurement deviation for the data.