2Pcs to Voltage Converter Module 0-1KHZ 0-10

Description:

- It can convert the frequency pulse signal to analog voltage signal, transform 0-1KHz frequency signal into 0-10V voltage output

- Adjusting

- frequency can change output voltage, can be applied to interface

- conversion between PLC and frequency converter or interface matching

- control occasions like motion control card and frequency converter, etc

- Adjusting potentiometer can calibrate the relationships between frequency and voltage

Specification:

- Operating voltage: 13.5V-30V

- Input frequency range: 0-1KHZ

- Output voltage range: 0-10V

- Size: Approx. 35mm x 33mm x 14mm

- Instructions for use

- VCC: Operating power supply

- GND: Power ground

- F: A input frequency pulse signal

- GND: input ground

- VOUT: output corresponding voltage

- GND: Output ground; Common ground for modules

- Connect the operating voltage to VCC and GND. Do not reverse it to avoid damaging the board and the device.

- Connect the frequency pulse signal to F and there is a corresponding voltage output at VOUT.

- Input and output corresponding relationship: 100HZ=1V, 1KHZ=10V.

- If there is a deviation in the correspondence between the use, adjust the potentiometer on the board to calibrate.

- The module accuracy is 1%, and it cannot be applied to fields which has high demanding of precision.

- Input different frequency, output will correspond to certain voltage.

- Input

- pulse level can be 5V, 12V, 24V, serial resistor not needed. But if you

- input signal frequency, the time should be more than 0.5s

- If you want to use it with PLC, it supports NPN. Please make sure that there is GND wire

- If you want to use it with encoder, it requires constant rotation of the encoder for more than 0.5s

Package Includes: 2Pieces Frequency to Voltage Converter Module